8/8/2023 0 Comments Slik u212 camera mount![]() Before you tighten the release lever to snug the camera to the base pad you slide this lip just beyond where your camera's bottom would contact it. One end of the gray part has a taller "lip" on it. NOTE: Between the pads is a little area with a gray sliding part. A quick release post is sitting on top of the pad to show you what it looks like. ![]() Hairyjames wrote: In photo two, taken from the same vantage point of your original photo, you'll see both black pads on mine. To snug up the camera, you'll then carefully rotate that lever CLOCKWISE until the camera becomes snug against the TWO rubber base pads. ![]() Once the lever is pointing as mine is, and you lift the end of the lever up, it will allow you to remove or insert the Slik quick release part you've ordered. In the first photo, you can only see the quick release post's threads sticking up that would normally have been already screwed into the mounted camera! I've included one of mine in both photos for a point of reference. Rotated to the 3 o'clock position like I've done will allow you to lift the lever's end, which will allow you to insert or release the Slik quick release part which you've ordered. In photo one, taken from the rear of the tripod head, you'll see my gray quick release lever pointing to the right. PHOTO ONE - OPERATING THE GRAY QUICK RELEASE LEVER NOTE: You'll see both pads on mine, in photo #2 below. It is much smaller, and on the left side of your picture. You still have the second mounting pad on your tripod. You are only missing the "rubber" mounting pad on the top of the head that was once held on by that glue, plus a quick release part (pictured below). I've been a happy U-212dlx owner since 1986 and still use it regularly. I registered here to answer your question. Posted: Sat 4:52 am Post subject: Answers to your Slik U212 Dlx head question You will notice that there is some remnant adhesive on top - no idea where this came from. Can someone with this tripod point me to the right key-word/part I need to buy? Unfortunately, available quick release posts on *bay don't look like the right fit. The missing piece should contain the screw (to thread into a camera). I purchased a Slik u212 deluxe tripod that's missing a mount-piece figuring that I would just buy it separately. The local Goodwill had a tripod like this - with the same piece missing! Posted: Fri 7:37 am Post subject: Re: Slik u-212 deluxe Tripod - missing mount-piece part Do you think that this is all I need? I am just wondering whether the missing rubber/plastic pad will result in the camera perching solely on the screw (i.e. The site you linked does have the "6121 Quick release post" for this tripod. My guess would be that the glue was there to hold a rubber pad in place, but I could be wrong. Sigma DP1, Nikon D40 ( hers ), Polaroid x530, Pentax P30t, Pentax P50, (P30t/P50 K-A to Nikon F body mount conversion) Scheimpflug wrote: My guess would be that the glue was there to hold a rubber pad in place, but I could be wrong.ĭoes this site have your quick-release part? I've never used them, they just came up in a Google search:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |